Home > Technical Articles

Test Pin Tolerance: Why Ø1.0 mm ±0.02 mm Is Not the Same as Ø1.0 mm

2026-11-18

The smallest probes in the IP and accessibility world are the least forgiving. A 1 mm pin with a 0.02 mm tolerance has two percent of its diameter to give, and both directions of error produce a wrong verdict rather than a failed measurement.

The reason is that these probes are not measuring instruments; they are pass or fail devices that represent a finger, a tool or a wire. Their size is the specification.

Error in both directions

DeviationEffect on the testDirection of the error
0.03 mm oversizeRefuses a slot that the real object entersFalse reject of the product
0.03 mm undersizeEnters a slot that should be closed to itFalse pass, the dangerous one
0.05 mm out of roundVerdict depends on rotationNot repeatable at all
Rounded tip, 0.1 mm radiusSlides past thin edgesFalse pass on thin-wall parts

The false pass is what matters. A probe that is small rejects good product and the fault is found in a week. A probe that is large accepts bad product and the fault is found in the field.

Making and keeping the tolerance

These pins are usually ground from hardened stock, then the tip is formed and the surface finished. Three things decide whether the finished pin holds its tolerance in service:

  • Hardness. Below about 50 HRC the tip deforms on the first firm contact with a metal edge.
  • Tip form. The specified radius is part of the size; a worn radius is a size change even when the diameter is nominal.
  • Straightness. A pin bent by 0.05 mm over 20 mm will not enter a straight slot, and the operator will blame the product.

Measure the diameter at three heights, the tip radius under a profile projector, and check straightness by rolling on a flat plate. Do that at purchase and again after every 500 insertions.

Storage is part of the tolerance

Two pins in the same drawer become one pin with a damaged tip. Keep them in individual tubes, cap the tips, and never let a pin share a box with a hammer. The cost of a tube is a fraction of the cost of a recall. Our IP and accessibility probe range is supplied with tip protection, and the insertion forces for each size are listed in the article list.

Standards referenced: IEC 61032, IEC 60529 clause 13.3 (probe C, Ø2.5 mm, 3 N), ISO 1 for the reference temperature of 20 °C.

The inspection interval that matches the wear

A 1 mm pin used 200 times a month with 0.02 mm of tolerance will not survive a 12 month interval: at a typical 0.002 mm loss per 1,000 insertions the pin is at the limit after 10,000 insertions, which is 4 years at that rate, but one drop can consume the whole tolerance in a second.

Check the diameter monthly and the tip radius quarterly; replace on the first out-of-tolerance reading, not on the annual review.

A 1 mm pin is small enough that a 0.5 mm chamfer on the tip is 50 percent of the diameter, which is why the tip form is specified separately from the size and why a worn tip passes a diameter check while failing every thin-wall part in the batch.

CONTACT US

Contact: Eason Wang

Phone: +86-13751010017

Tel: +86-755-33168386

Email: info@iec-equipment.com

Add: 1F Junfeng Building, Gongle, Xixiang, Baoan District, Shenzhen, Guangdong, China

close
Scan the qr codeClose
the qr code